Red Dot Laser Alignment for Accurate Dot Measurement

There is more than one time when red dot laser alignment is being used for reference dot measurement in most of industrial alignment field. This advanced laser tech applied gadget is widely applied in various kinds of industrial dot emitting fields such as laser marking machine, textile industry such as garment button positioning, laser engraving machine or metal melting etc. Not the same as commonly used dot measurement gadget, this laser alignment is always able to make the most accurate and precise dot projection on targeted surfaces stably and reliably.

The time users are making long time dot projection, it is just configured with outside designed DC input power supply so as to make continuous dot measurement constantly. Once red dot laser alignment is connected with electric power supply, it will begin work constantly. No matter at close or long operating distance, this red dot laser alignment is just making super bright red reference dot clearly and accurately. In addition, its finest configuration of inner electric circuit board has super strong interference ability. Thus it is always able to make highly accurate and precise dot generation on targeted surfaces successfully and stably.
Whenever users are making long distance dot projection, it is necessary to select a high power laser with an output power of up 30mW. Only if the output power is high enough, users can just get the most satisfied reference dot projection at required distance. Otherwise, a low powered laser is not bright and visible enough to make a super long distance dot projection. On condition that users are using high powered alignment lasers, it is quite necessary to wear laser safety goggles in order to make full protection of eyes from strong radiation from 650nm red laser diode.
When users are making dot projecting with this red laser alignment, people should be totally acknowledgeable with concerned laser operating safety measures and rules. It should never be pointed directly to human eyes since powerful laser radiation might be harmful to eyes. In addition, the electric power line should also not be thrown or jumped seriously, otherwise, it might cause break of electric line and bad connection. No matter what output power users have chosen, the alignment laser should not be powered with too higher or too lower output power. The maximum power supply voltage should not exceed 5V. Once the pointing current is too higher, the inner 650nm red laser diode and circuit board might be easily burnt out temporarily. On contrary, it might be not efficient enough to project highly bright and accurate red reference dot clearly on targeted surfaces. Thus users should choose the most appropriate red dot laser alignment until getting the best dot projecting result successfully and accurately.